Room Noise Detector

One LED monitors three levels: 50, 70 & 85 dB

Useful to detect too noisy environments

Parts:

R1____________10K   1/4W Resistor
R2,R3_________22K   1/4W Resistors
R4___________100K   1/4W Resistor
R5,R9,R10_____56K   1/4W Resistors
R6_____________5K6  1/4W Resistor
R7___________560R   1/4W Resistor
R8_____________2K2  1/4W Resistor
R11____________1K   1/4W Resistor
R12___________33K   1/4W Resistor
R13__________330R   1/4W Resistor

C1___________100nF  63V Polyester Capacitor
C2____________10µF  25V Electrolytic Capacitor
C3___________470µF  25V Electrolytic Capacitor
C4____________47µF  25V Electrolytic Capacitor

D1_____________5mm. Red LED

IC1__________LM358  Low Power Dual Op-amp

Q1___________BC327  45V 800mA PNP Transistor

MIC1_________Miniature electret microphone

SW1__________2 poles 4 ways rotary switch

B1___________9V PP3 Battery

Clip for PP3 Battery

Device purpose:

This circuit is intended to signal through a flashing LED, the exceeding of a fixed threshold in room noise, chosen from three fixed levels, namely 50, 70 & 85 dB. Two Op-amps provide the necessary circuit gain for sounds picked-up by a miniature electret microphone to drive a LED. With SW1 in the first position the circuit is off. Second, third and fourth positions power the circuit and set the input sensitivity threshold to 85, 70 & 50 dB respectively.
Current drawing is <1mA with LED off and 12-15mA when the LED is steady on.

Use:

• Place the small box containing the circuit in the room you intend to measure ambient noise.
• The 50 dB setting is provided to monitor the noise in the bedroom at night. If the LED is steady on, or flashes bright often, then your bedroom is inadequate and too noisy for sleep.
• The 70 dB setting is for living-rooms. If this level is often exceeded during the day, your apartment is rather uncomfortable.
• If noise level is constantly over 85 dB, 8 hours a day, then you live in a dangerous environment.